Minolta PI4700E - Manual (Page 408)

Setting Up IP Parameters 12
Pi4700e 12-57
A
ppe
ndi
x
Chap
ter
12
✎
Note
When the Network Card host name is already registered in the hosts
file (
/etc/hosts ), you can use the host name in place of the IP address.
Example:
When the entry below is registered in the hosts file.
192.9.200.299 printfast
arp -s printfast 00:20:6b:aa:bb:cc
✎
Note
ARP can be used to assign an IP address only. Other IP parameters
must be set using Telnet or a Web browser. For details, see “12.8 Us-
ing Telnet to Make Settings” (p. 12-61) and PageScope Light for
Pi5501 Operator’s Manual.
You cannot use ARP to assign an IP address if the Network Card has
already been assigned an IP address by ATIP.
Assigning IP Addresses Using the BOOTP Daemon (For
UNIX)
1 Power down the Digital Copier.
2 On a computer associated with the same network segment as the Dig-
ital Copier, log on as root.
3 If the BOOTP daemon is already running, stop it.
4 Edit /etc/bootptab by adding the following.
<NIC host name>:\
:ht = <hardware type>:\
:ha = <ethernet Address>:\
:ip = <IP address>:\
:sm = <subnet mask>:\
:gw = <gateway address>:
Example:
RFC 1048 Standard
MAC Address: 00:20:6B:AA:BB:CC
IP Address: 192.19.200.200
Subnet Mask: 255.255.255.0
Gateway Address: 192.9.200.10