Minolta PI4700E - Manual (Page 347)

11 Unable to Print
11-4 Pi4700e
T
ro
ubl
es
hoo
ting
Ch
apte
r 11
Unable to staple
properly. No stapling can be effected if the
type of paper is thick paper or
OHP transparencies. Check the type of paper.
When Mailbin Finisher or Multi-
staple Finisher is installed, no
stapling can be effected if num-
ber of prints to be made exceeds
50. Check the number of prints to be
made.
When Single-staple Finisher is
installed, no stapling can be ef-
fected if number of prints to be
made exceeds 30.
No stapling can be effected if the
number of pages to be printed is
50 or more when a Folding Fin-
isher is mounted. Center Staple
is also disabled if the number of
pages to be printed is 15 or
more.
No stapling can be effected if
original document contains pag-
es of different sizes.
The stapling position
is opposite to what is
expected. The paper direction and N-up do
not match the setting made for
Orientation. Change the setting for Orienta-
tion.
Unable to specify
Punch. Either a Multi-staple Finisher,
Mailbin Finisher or Folding Fin-
isher must be mounted to enable
the setting of Punch, and “Multi-
staple Finisher”, “Mailbin Finish-
er” or “Folding Finisher” must be
selected from “Installable Op-
tions” to specify Punch. Select “Multi-staple Finisher”
“Mailbin Finisher” or “Folding
Finisher” from “Installable Op-
tions.”
Punch cannot be specified if
Booklet or OHP interleaving is
specified. Check the setting of Booklet and
OHP Interleaving.
Unable to effect
Punch. No holes can be made if the type
of paper is thick paper or OHP
transparencies. Check the type of paper.
Prints can at times be fed out
without being punched if the di-
rection of the paper loaded in the
paper source is not appropriate. Check the direction of the paper.
The hole punch posi-
tion is opposite to
what is expected. The paper direction and N-up do
not match the setting made for
Orientation. Change the setting for Orienta-
tion.
Symptom Possible Cause Action