Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 22)

6. Tie Angles, Ladders and Safety Cages
22 PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series
Attach Boot Ladder Support Brackets to Boot Tie Angle
NOTE: Refer to ladder layout images, Figure 5A-5G on Pages 13-19 .
NOTE: Ladder can be mounted to either the up-leg or the down-leg of the elevator depending on the
height and head platform hatch location. Double check if the ladder should start on the up-leg
or down-leg.
NOTE: Both the up-leg and down-leg ladder bracket locations are shown in this manual. Actual installation
location on either the up-leg or the down-leg will be determined by owner preference.
1. 42" Up-Leg Boot Brackets: Use 3/8" x 1" HHCS bolts (S-7469) and 3/8" flange nuts (S-10028) to
attach the ladder support brackets (LAD1648TRH and LAD1648TLH) to the bottom of the boot tie
angle using holes indicated.
(See Figure 6C.)
Figure 6C 42" Up-Leg Boot Bracket
2. 42" Down-Leg Boot Brackets: Use 3/8" x 1" HHCS bolts (S-7469) and 3/8" flange nuts (S-10028)
to attach the ladder support brackets (LAD1648TRH and LAD1648TLH) to the bottom of the boot tie
angle using holes indicated.
(See Figure 6D.)
Figure 6D 42" Down-Leg Boot Bracket