Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 33)

6. Tie Angles, Ladders and Safety Cages
PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series 33
Attach Ladder Support Brackets to Tie Angles for 48"
1. For 48" Ladder Brackets: Mount the upper left and upper right hand brackets (LAD48TLHTX and
LAD48TRHTX) to the top tie angles.
2. Mount the lower left and lower right hand brackets (LAD48TLHBX and LAD48TRHBX) to the bottom
tie angles.
3. Fasten flanges of brackets and brackets to tie angles using 3/8" x 1" HHCS bolts (S-7469) and
3/8" flange nuts (S-968). (See Figure 6R below, Figure 6S and Figure 6T on Page 34.)
NOTE: You will only use one set of brackets, either the up-leg set or the down-leg set depending on
your ladder location.
Figure 6R 48" Ladder Support Bracket Parts