Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 52)

8. 42" Head Platform Left Hand Drive
52 PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series
3. Attach two (2) the support channels to the brackets located on the lower head. Fasten using
1/2" x 1" HHCS bolts (S-7935) and 1/2" flange nuts (S-8506). (See Figure 8B below and Figure 8C
on Page 53.)
NOTE: Third channel is installed later. (During the installation of decking on the up-leg hatch side.)
NOTE: Support channels should extend farther on the drive side than on the hatch side of the
lower head.
Figure 8B