Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 87)

9. 48" Head Platform Right Hand Drive
PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series 87
Install Handrails
NOTE: Position bolt heads to the inside of the platform.
NOTE: Posts should be finger-tightened only until handrails have been installed. Some “free play” will be
required to property fit the handrails in place.
1. Loosely install handrails to the top of the posts (HP1648HCP) as shown in Figure 9R using
5/16" x 2" HHCS bolts (S-7877) and 5/6" flange nuts (S-3611).
2. Once all handrails are in place, fully tighten platform posts to the toe boards and fully tighten the
handrails to the posts. (See Figure 9R.)
Figure 9R