Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 86)

9. 48" Head Platform Right Hand Drive
86 PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series
Install Platform Post
NOTE: Position bolt heads to the inside of the platform.
NOTE: Posts should be finger-tightened only until handrails have been installed. Some “free play” will be
required to property fit the handrails in place.
1. Install platform post to the “Z” toe boards with the flat side to the toe board spacing them as shown
in Figure 9Q .
2. Fasten middle post to toe boards using four 5/16" x 1" flange bolts (S-7470) and 5/16" flange
nuts (S-3611).
3. Fasten corner posts to toe boards using six 5/16" x 1" flange bolts (S-7470) and 5/16 flange
nuts (S-3611). (See Figure 9Q.)
Figure 9Q