Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 27)

6. Tie Angles, Ladders and Safety Cages
PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series 27
Attach Tie Angles to Trunking
NOTE: Tie angles must be installed at every trunking seam on both the ladder and non-ladder sides.
The bottom tie angle will be replaced with a rest platform tie angle (RP42CHNLX for 42" and
RPCHNLX2 for 48") where a rest platform is to be installed.
NOTE: When installing the tie angles, the notched side must face out away from the trunk and the side
with the straight edge must be installed against the trunking angles.
Two (2) tie angles are installed for both the ladder and non-ladder sides.
1. For 42" Tie Angles: Install two (2) tie angles (GECT4204X or BECT4204X) to both sides of the
trunking seam using 1/2" x 1" HHCS bolts (S-7935) and 1/2" flange nuts (S-8506). Installation is the
same for both the ladder and non-ladder sides.
(See Figure 6J below and Figure 6K on Page 28.)
Figure 6J 42" Tie Angle Installation Locations