Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 66)

8. 42" Head Platform Left Hand Drive
66 PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series
Install Handrails
NOTE: Position bolt heads to the inside of the platform.
NOTE: Posts should be finger-tightened only until handrails have been installed. Some “free play” will be
required to property fit the handrails in place.
1. Loosely install hand rails to the top of the posts (HP1648HCP) as shown in Figure 8P using
5/16" x 2" HHCS bolts (S-7877) and 5/6" flange nuts (S-3611).
2. Once all handrails are in place, fully tighten platform posts to the toe boards and fully tighten the
handrails to the posts. (See Figure 8P.)
Figure 8P