Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 70)

8. 42" Head Platform Left Hand Drive
70 PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series
4. Install magnets (HP1648MAG) to the latch bracket (HSP4248LMM) using #10-24 HWHS screws
(S-6145) and #10-24 nylock nuts (S-2010).
5. Open hatch fully and note where it rests against the platform post. Lower the hatch.
6. Install “X” series latch bracket assembly (HSP4248LMM and HP1648MAG) to this post where the
hatch meets the post using 5/16" x 1" flange bolts (S-7470) and 5/16" flange nuts (S-3611) through
the holes in the side of the post.
(See Figure 8T.)
7. Raise the hatch, making sure it is flush against the magnets and holds the hatch securely in place.
Figure 8T