Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 78)

9. 48" Head Platform Right Hand Drive
78 PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series
2. Locate the large holes in decking (HSP48011X) and orient the decking so that the end of the decking
with the greater length from the holes is towards the lower head. Simultaneously install the deck
plank (HSP48012X) between the two (2) deck planks with the large holes (HSP48011X).
3. Insert deck channel support angles (HSP484038) through the outside holes of the decking and attach
all three (3) decking planks to the toe board (HSP48044X) and cross support channel (HSP482007X)
using 5/16" x 1" flange bolts (S-7470) and 5/16" flange nuts (S-3611).
4. Attach deck channel support angles (HSP484038) to the lower head bearing angle (42HDBRGN)
using 3/8" x 1" HHCS bolts (S-7469) and 3/8" flange nut (S-10028).
Figure 9I
Decking Installation
IMPORTANT: Install ALL decking by starting next to the toe board and working outward. Planks must be
firmly seated next to each other.