Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 56)

8. 42" Head Platform Left Hand Drive
56 PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series
Deck Channel Support Angle to Cross Channel
NOTE: Support angles go through the deck plates. Therefore, two (2) decking planks will be installed at
the same time as the support angles.
1. Attach the deck channel support angles (HSP42014) to the remaining support channel (HSP42032X)
using 3/8" x 1" HHCS bolts (S-7469) and 3/8" flange nuts (S-10028). (See Figure 8F.)
NOTE: This channel is oriented opposite of the channels previously installed to the lower head.
Figure 8F