Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 67)

8. 42" Head Platform Left Hand Drive
PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series 67
Attach Intermediate Handrails to Posts
1. Cut 14" off the tube end of three (3) small intermediate handrails (LDR-4088) and three (3) large
intermediate handrails (LDR-4087). (See Figure 8Q.)
2. Slide the small rail into the large rail and install one set at discharge end and other two (2) sets
opposite the discharge end on hatch side and adjust to fit.
3. Fasten using 5/16" x 1" flange bolts (S-7470) and 5/16" flange nuts (S-3611).
4. Install the remaining intermediate handrails around the platform using 5/16" x 1" flange bolts (S-7470)
and 5/16 flange nuts (S-3611).
Figure 8Q