XLT Hitachi X200 - Manual (Page 145)

Miscellaneous Functions
The following table contains miscellaneous functions not in other function groups.
“C” Function Defaults
Func.
Code
Name /
SRW Display
Description
Run
Mode
Edit
-FE
(EU)
-FU
(USA)
Units
Debug mode enable * C091
DBG Slct OFF
Displays debug parameters.
Two option codes:
00
}Disable
01 }Enable <Do not set>
(for factory use)
9 00 00 
Up/Down memory mode
selection C101
UP/DWN NO-STR
Controls speed setpoint for the
inverter after power sycle.
Two option codes:
00
}Clear last frequency (return to
default frequency F001)
01 }Keep last frequency adjusted
by UP/DWN
U 00 00 
Reset selection C102
RS Slct ON
Determines response to Reset
input [RS].
Three option codes:
00
}Cancel trip state at input
signal ON transition, stops
inverter if in Run Mode
01 }Cancel trip state at signal
OFF transition, stops inverter
if in Run Mode
02 }Cancel trip state at input ON
transition, no effect if in Run
Mode
U 00 00 
CAUTION: Do not change Debug mode for safety reasons. Otherwise unexpected
performances may occur.
3 62
Config
uri
ng Driv
e
Parameters
3 −62
&RQ¿JXULQJ'ULYH
Parameters