XLT Hitachi X200 - Manual (Page 156)

Intelligent Terminal Listing
Intelligent Inputs
Use the following table to locate pages for intelligent input material in this chapter.
Input Function Summary Table
Symbol Code Function Name Page
FW 00 FORWARD Run/Stop 4-11
RV 01 Reverse Run/Stop 4-11
CF1 02 Multi-speed Select, Bit 0 (LSB) 4-12
CF2 03 Multi-speed Select, Bit 1 4-12
CF3 04 Multi-speed Select, Bit 2 4-12
CF4 05 Multi-speed Select, Bit 3 (MSB) 4-12
JG 06 Jogging 4-14
DB 07 External DC braking 4-15
SET 08 Set (select) 2nd Motor Data 4-16
2CH 09 2-stage Acceleration and Deceleration 4-17
FRS 11 Free-run Stop 4-18
EXT 12 External Trip 4-19
USP 13 Unattended Start Protection 4-20
SFT 15 Software Lock 4-21
AT 16 Analog Input Voltage/Current Select 4-22
RS 18 Reset Inverter 4-23
PTC 19 PTC thermistor Thermal Protection 4-24
STA 20 Start (3-wire interface) 4-25
STP 21 Stop (3-wire interface) 4-25
F/R 22 FWD, REV (3-wire interface) 4-25
PID 23 PID Disable 4-26
PIDC 24 PID Reset 4-26
UP 27 Remote Control UP Function 4-27
DWN 28 Remote Control Down Function 4-27
UDC 29 Remote Control Data Clearing 4-27
OPE 31 Operator Control 4-29
ADD 50 ADD frequency enable 4-30
F-TM 51 Force Terminal Mode 4-31
RDY 52 Inverter ready 4-31
SP-SET 53 Special Set 4-16
EMR 64 Emergency Stop 4-32
NO 255 No assign -
Intelligent Outputs
Use the following table to locate pages for intelligent output material in this chapter.
Input Function Summary Table
Symbol Code Function Name Page
00 RUN Run Signal 4-39
01 FA1 Frequency Arrival Type 1–Constant Speed 4-40
02 FA2 Frequency Arrival Type 2–Over frequency 4-40
03 OL Overload Advance Notice Signal 4-42
04 OD Output Deviation for PID Control 4-43
05 AL Alarm Signal 4-44
06 Dc Analog Input Disconnect Detect 4-46
07 FBV PID Second Stage Output 4-47
08 NDc Network Detection Signal 4-50
09 LOG Logic Output Function 4-52
10 ODc Network error detection 4-53
43 LOC Low load detection signal 4-54
4 7
Operations and
Monitori
ng
4 −7
Operations and
Monitoring