Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 142
112
Multi-Service IronWare Switching Configuration Guide
53-1003036-02
LAG formation rules
5
•
Make sure the device on the other end of the LAG link can support the same number of ports
in the link.
displays an example of a valid, Keep ALIVE LAG link between two devices. This
configuration does not aggregate ports but uses the LACP PDUs to maintain the connection status
between the two ports.
FIGURE 3
Example of a 1-port keep alive LAG
shows an example of a valid 2-port LAG link between devices where the ports on each end
are on the same interface module. Ports in a valid 2-port LAG on one device are connected to two
ports in a valid 2-port LAG on another device.
FIGURE 4
Example of 2-port LAG
shows an example of two devices connected over a 4 port LAG where the ports on each
end of the LAG are on different interface modules.
TABLE 24
The LAG/member configuration
Maximum number of
1/10G LAGs
Maximum number
of 1/10G LAG
ports
Maximum number
of 100/40G LAG
ports
Maximum number of
100/40G LAGs possible
Maximum number of LAGs
in the system
256
8
2 to 8
16 for 8-ports
64 for 2-ports
256
128
16
2 to 16
8 for 16-ports
64 for 2-ports
128
64
32
2 to 32
4 for 32-ports
64 for 2-ports
64
32
64
2 to 64
2 for 64-ports
64 for 2-ports
32