Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 666)

636 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
About Multi-Chassis Trunk (MCT)
18
Manually synchronizing all client MAC entries
The cluster sync-cluster-mac client-all command synchronizes all configured client MAC entries
between MCT peers.
Brocade#Cluster sync-cluster-mac client-all
Cluster - Macs Requested from Peer for all Clients
Manually synchronizing a single MAC entries
The cluster sync-cluster-mac mac HHHH.HHHH.HHHH.vlan-id xxxx command synchronizes the
specified MAC entry specific to a VLAN from the MCT peer.
Brocade#Cluster sync-cluster-mac mac 001b.eda4.1d41 vlan-id 8
Cluster - Mac Update Requested from peer
Set the client-interfaces delay value
Use the client-interfaces delay command to set the delay before brining up the CCEP port. This
command is used to set the delay, so that after a node is reloaded, with just L2vpn peer alone, the
delay to bring up the CCEP port will be the designated value.
Brocade(config-cluster-TOR)#client-interfaces delay 60
Syntax: [no] client-interfaces delay time in sec
The default value for delay is 30 seconds. The acceptable values range between 20 to 600
seconds.
NOTE
Client-interface delay is only applied with just L2 VPN. It does not support L2+L2VPN.
Enabling Cluster MAC synchronization
MAC table learning allows periodic synchronization between MCT peers, based on a configured
value (in minutes). If cluster MAC synchronization is enabled but no value is specified, the default
synchronization value is 15 minutes.
NOTE
Cluster MAC synchronization is disabled by default.
To enable cluster MAC synchronization for all configured clients in cluster mode, enter the
cluster-mac-sync command.
Brocade(config-cluster-TORA)# cluster-mac-sync
Syntax: cluster-mac-sync
Disabling Cluster MAC synchronization
The no version of the cluster-mac-sync command disables the cluster MAC synchronization for all
configured clients in cluster mode.
Brocade(config-cluster-TORA)# no cluster-mac-sync
Syntax: [no ]cluster-mac-sync