Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 244)

214 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Displaying multi-port static MAC address information
7
Error: port 4/11 is part of multiport-mac and cannot be added as secondary
port of a trunk
• When a LAG primary port is part of a multi-port static MAC address, the LAG cannot be
undeployed or deleted. Also, when a non-LAG port is part of a multi-port static MAC address,
you cannot deploy a LAG with that port. These configurations will be rejected. The following are
the sample error messages for each of these cases:
- Veto check for deploying LAG.
Brocade(config-lag-LAG1)#deploy
Error: LAG LAG1 primary port 4/11 is configured as part of a multi-port mac
entry, cannot deploy the LAG
- Veto check for undeploying LAG.
Brocade(config-lag-LAG2)#no deploy
Error: The primary port 4/15 is configured as part of a multi-port mac
entry, cannot undeploy the LAG
- Veto check for deleting LAG.
Brocade(config)#no lag LAG2
Error: The primary port 4/15 is configured as part of a multi-port mac
address, cannot remove the LAG
• A port belonging to a multi-port static MAC address is not allowed to be removed from a VLAN
unless it is removed from all the multi-port static MAC addresses.
Brocade(config-vlan-100)#no tag e 2/19
Error - port 2/19 is configured as part of a multi-port mac address, cannot
remove port from vlan
• Module configuration deletion (no module) will be rejected if any of the ports in that module
are configured as part of any multi-port static MAC addresses.
Brocade(config)#no mod 4 ni-mlx-20-port-1g-100fx
Error - module 4 has ports that are member of the multi-port mac addresses,
Cannot remove the module
Displaying multi-port static MAC address information
You can display the following information about multi-port static MAC addresses on the device:
• Running configuration
• Changes in the MAC table
• M-port debug information
• LP information
Displaying running configuration
To display the running configuration information of multi-port static MAC addresses, enter the
following command.
Brocade# show run
vlan 10
tagged ethe 1/1 to 1/20 ethe 2/1 to 2/48
static-mac-address 0100.5e42.7f40 multi-ports ethe 1/1 to 1/3