Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 983)

Multi-Service IronWare Switching Configuration Guide 953
53-1003036-02
Displaying MPLS BFD information
25
Displaying MPLS BFD global configuration information
You can use the show mpls bfd command to display the global configuration information for a
device, as shown in the following.
Syntax: show mpls bfd
TABLE 133 Display of BFD MPLS detail command
This field... Displays...
MPLS BFD admin The global configuration state of MPLS BFD on the device: can be either
Enabled or Disabled
Minimum TX interval Desired Min Tx Interval - the minimum interval, in microseconds, the local
system will use when transmitting BFD Control packets. The value zero is
reserved.
Minimum RX interval Required Min Rx Interval - the mimi num interval, in microseconds, between
received BFD Control packets that this system is capable of supporting. If this
value is zero, the transmitting system does not want the remote system to
send any periodic BFD Control packets.
Detection time multiplier The number of times in a single sequence this device waits to receive a BFD
message from the peer before determining that the connection to that peer is
not operational.
Brocade# show mpls bfd
MPLS BFD admin = Enabled
Minimum TX interval = 1000 msec
Minimum RX interval = 1000 msec
Detection time multiplier = 3