Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 248)

218 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
system-max tvf-lag-lb-fid-pool
7
system-max tvf-lag-lb-fid-pool
Configures maximum FID pool size for transparent VLAN flooding LAG load balancing globally.
Syntax [no] system-max tvf-lag-lb-fid-pool number
Command
Default
None
Parameters number Specifies the decimal value of FID pool size defined. Valid from 0
through 2048 (Default is 0, setting the value as 0 will disable transparent
VLAN flooding LAG load balancing globally).
Command
Modes
Global configuration mode
Usage
Guidelines
The system-max tvf-lag-lb-fid-pool command configures maximum pool size for transparent VLAN
flooding LAG load balancing globally. Use no system-max tvf-lag-lb-fid-pool command to disable the
pool size configuration. Pool size can be defined from 0 through 2048 (Default is 0, setting the
value as 0 will disable transparent VLAN flooding LAG load balancing globally).
NOTE
After configuring pool size execute write memory command and restart the router, else it could
cause instability on fail over.
Examples The following example shows how to configure max pool size for transparent VLAN flooding LAG
load balancing:
Brocade(config)#system-max tvf-lag-lb-fid-pool number
To disable max pool size configuration use the following command:
Brocade(config)#no system-max tvf-lag-lb-fid-pool number
Related
Commands
system-max tvf-lag-lb-fid-group number
Release Command History
Multi-Service IronWare
R05.6 This command was introduced.