System-max tvf-lag-lb-fid-group – Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 249
Multi-Service IronWare Switching Configuration Guide
219
53-1003036-02
system-max tvf-lag-lb-fid-group
7
system-max tvf-lag-lb-fid-group
Configures maximum FID group size for transparent VLAN flooding LAG load balancing globally.
Syntax
[no] system-max tvf-lag-lb-fid-group number
Command
Default
None
Parameters
number
Specifies the decimal value of the FID number defined per
group. Valid values are 2, 4, 8.
Command
Modes
Global configuration mode
Usage
Guidelines
The system-max tvf-lag-lb-fid-group command configures maximum FID group size for transparent
VLAN flooding LAG load balancing globally. Use no system-max tvf-lag-lb-fid-group command to
disable the groups configured. Valid values defined per group are 2, 4, 8.
NOTE
After configuring group size execute write memory command and restart the router, else it could
cause instability on failover.
Examples
The following example shows how to configure max group size for transparent VLAN flooding LAG
load balancing:
Brocade(config)#system-max tvf-lag-lb-fid-group number
To disable max group size configuration use the following command:
Brocade(config)#no system-max tvf-lag-lb-fid-group number
Related
Commands
system-max tvf-lag-lb-fid-pool number
Release
Command History
Multi-Service IronWare
R05.6
This command was introduced.