Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 58
28
Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Link fault signaling
1
PORT 2/1: RX ON TX ON
PORT 2/2: RX ON TX ON
TX LFS is enabled on all ports and RX LFS is enabled on all ports.
Brocade(config)#int e 2/1
Brocade(config-if-e10000-2/1)#no link-fault-signaling
Brocade(config-if-e10000-2/1)#show run
Current configuration:
!
ver V5.3.0pT183
!
no spanning-tree
!
vlan 1 name DEFAULT-VLAN
!
hostname Brocade
link-fault-signaling
!
interface ethernet 2/1
no link-fault-signaling
!
end
Brocade(config-if-e10000-2/1)#show link-fault-signaling
Global Link Fault : RX ON TX ON
PORT #: LINK FAULT:
PORT 2/1: RX ON TX OFF
PORT 2/2: RX ON TX ON
TX LFS is enabled on all ports except 2/1 and RX LFS is enabled on all ports.
Brocade(config-if-e10000-2/1)#exit
Brocade(config)#link-fault-signaling
Brocade(config)#show run
Current configuration:
!
ver V5.3.0pT183
!
no spanning-tree
!
vlan 1 name DEFAULT-VLAN
!
hostname Brocade
link-fault-signaling
!
end
Brocade(config)#show link-fault-signaling
Global Link Fault : RX ON TX ON
PORT #: LINK FAULT:
PORT 2/1: RX ON TX ON
PORT 2/2: RX ON TX ON
TX LFS is enabled on all ports and RX LFS is enabled on all ports. The previously configured no
link-fault-signaling on port 2/1 is overwritten by the global TX LFS enable.