Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 892)

862 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Multiple VLAN Registration Protocol
20
Enabling MVRP when VLAN group is configured
When MVRP is enabled while VLAN group is configured, the following error message is displayed.
Error - Please remove all VLAN group configurations before running MVRP
Enabling MVRP over VPLS end point port
When MVRP is configured over a port which is also a VPLS end point, the following error message is
displayed.
Error - MVRP cannot be enabled on port 1/1 as it is configured as a VPLS end point
Enabling MVRP over port with non-default port-type
When MVRP is enabled over a port with non-default port-type, the following error message is
displayed.
Error - MVRP cannot be enabled on port 1/1 as its port-type has been changed for
PB-PBB network
Running per VLAN instance of STP or RSTP when MVRP is enabled
For example, assume per VLAN STP or RSTP is running. Now, while enabling MVRP on the system,
the following error message is displayed.
Error - Please disable mvrp protocol before running STP on vlan 10.
Enabling MSTP when MVRP is configured
When MSTP is enabled while MVRP is configured, the following error message is displayed.
Error - Please disable mvrp protocol before running MSTP on vlan 10.
Enabling metro ring when MVRP is configured
When metro ring is enabled while MVRP is configured, the following error message is displayed.
Error - Please disable mvrp protocol before running MRP on VLAN 10.
Enabling ERP when MVRP is configured.
When ERP is enabled while MVRP is configured, the following error message is displayed.
Error - Please disable mvrp protocol before running ERP on VLAN 10.
Enabling VSRP when MVRP is configured
When VSRP is enabled while MVRP is configured, the following error message is displayed.
Error - Please disable mvrp protocol before running VSRP on VLAN 10.
Enabling topology group when MVRP is configured
When a topology group is configured while MVRP is configured, the following error message is
displayed.
Error - Please disable mvrp before configuring topology group.
Enabling VLAN group when MVRP is configured
When vlan-group is configured while MVRP is configured, the following error message is displayed.
Error - Please disable MVRP before configuring vlan group.
Adding port to VPLS vlan when MVRP is configured over the same port
When an MVRP enabled port is added to a VPLS VLAN, the following error message is displayed.
Error - Port %p cannot be a VPLS end-point, due to mvrp configuration.