Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 496)

466 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
RSTP support for PB and PBB
13
Configuring ES-1
NOTE
The configuration of ES-2 is similar to the configuration of ES-1.
Tag type configuration
Configure port tag type for S-VLAN to 0x9100.
Brocade_ES-1(config)#tag-type 9100 eth 1/2
Brocade_ES-1(config)#tag-type 9100 eth 1/3
S-VLAN Configuration
Configure VPLS VLANs which will carry the PB traffic, the S-VLAN here is 200.
Brocade_ES-1(config)#router mpls
Brocade_ES-1(config-mpls)#vpls pb-svlan 1
Brocade_ES-1(config-mpls-vpls-pb-svlan)#pbb
Brocade_ES-1(config-mpls-vpls-pb-svlan-pbb)#vlan 200
Brocade_ES-1(config-mpls-vpls-pb-svlan-vlan-200)#tag ethernet 1/2 ethernet 1/3
RSTP Configuration
Brocade_ES-1(config-mpls-vpls-pb-svlan-vlan-200)#rstp
CS-1 Configuration:
NOTE
The configuration of CS-2 is similar to the configuration of CS-1, except for the RSTP priority
configuration.
Port type configuration
Brocade_CS-1(config)#tag-type 88e8 eth 1/1
Brocade_CS-1(config)#tag-type 88e8 eth 1/2
Brocade_CS-1(config)#tag-type 88e8 eth 1/2
B-VLAN Configuration
Brocade_CS-1(config)#vlan 100
Brocade_CS-1(config-vlan-100)#tagged ethernet 1/1 ethernet 1/4 ethernet 1/5
RSTP Configuration
Brocade_CS-1(config-vlan-100)#rstp
Brocade_CS-1(config-vlan-100)#rstp priority 100
NOTE
There can be scenarios where the S-VLAN used on ES-1 is different from one used on ES-2. This
requires the configuration of different S-VLANs on AS-1 and AS-2.