Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 505
Multi-Service IronWare Switching Configuration Guide
475
53-1003036-02
Metro Ring Protocol (MRP)
14
For each discrete ring one node is configured in the master role for the MRP ring. One of the two
ring interfaces on the master node is configured as the primary interface, the other is the
secondary interface. The primary interface originates Ring Health Packets (RHPs) which are used
to monitor the health of the ring. An RHP is forwarded on the ring to the next interface until it
reaches the secondary interface of the master node. On receipt of an RHP the secondary interface
transitions into blocking mode to prevent a layer 2 loop.
displays the individual Brocade devices and the MRP features they support.
NOTE
When you configure MRP, it is recommended that you disable the secondary ring interface on the
master node before beginning or changing the ring configuration. Disabling an interface prevents a
layer 2 loop from occurring while you are configuring MRP on the ring nodes. Once you have
completed the MRP configuration and enabled it on all the nodes, you should re-enable the
secondary ring interface.
TABLE 62
Supported Brocade MRP features
Features
supported
Brocade
NetIron XMR
Brocade
MLX series
Brocade
NetIron CES
2000 Series
BASE
package
Brocade
NetIron CES
2000 Series
ME_PREM
package
Brocade
NetIron CES
2000 Series
L3_PREM
package
Brocade
NetIron CER
2000 Series
Base
package
Brocade
NetIron CER
2000 Series
Advanced
Services
package
MRP Phase 1
Yes
Yes
Yes
Yes
Yes
Yes
Yes
MRP Phase 2
Yes
Yes
Yes
Yes
Yes
Yes
Yes
MRP Alarm RHP Yes
Yes
Yes
Yes
Yes
Yes
Yes
MRP and MRP-II
support under
an ESI with
support for
B-VLANs,
S-VLANs and
C-VLANs
No
No
No
Yes
No
No
Yes
MRP
Diagnostics
Yes
Yes
Yes
Yes
Yes
Yes
Yes