Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 603)

Multi-Service IronWare Switching Configuration Guide 573
53-1003036-02
Displaying VSRP information
16
On a devices where the VSRP Fast Start feature is enabled.
Syntax: show vsrp [vrid num | vlan vlan-id]
This display shows the following information when you use the vrid num or vlan vlan-id parameter.
For information about the display when you use the aware parameter, refer to
“Displaying the active
interfaces for a VRID” .
TABLE 70 CLI display of VSRP VRID or VLAN information
This field... Displays...
Total number of VSRP
routers defined The total number of VRIDs configured on this device.
VLAN The VLAN on which VSRP is configured.
auth-type The authentication type in effect on the ports in the VSRP VLAN.
VRID parameters
VRID The VRID for which the following information is displayed.
state This device’s VSRP state for the VRID. The state can be one of the following:
•
initialize – VSRP is not enabled on the VRID. If the state remains
“initialize” after you enable VSRP on the VRID, make sure that the VRID is
also configured on the other routers Routing Switches and that the
routers Routing Switches can communicate with each other.
NOTE: If the state is “initialize” and the mode is incomplete, make sure you
have specified the IP address for the VRID.
•
standby – This device is a Backup for the VRID.
•
master – This device is the Master for the VRID.
Administrative-status The administrative status of the VRID. The administrative status can be one of
the following:
•
disabled – The VRID is configured on the interface but VSRP or VRRP-E
has not been activated on the interface.
•
enabled – VSRP has been activated on the interface.
Advertise-backup Whether the device is enabled to send VSRP Hello messages when it is a
Backup. This field can have one of the following values:
•
disabled – The device does not send Hello messages when it is a Backup.
•
enabled – The device does send Hello messages when it is a Backup.
Brocade(config-vlan-100-vrid-100)#show vsrp vrid 100
VLAN 100
auth-type no authentication
VRID 100
========
State Administrative-status Advertise-backup Preempt-mode
master enabled disabled true
Parameter Configured Current Unit/Formula
priority 100 50 (100-0)*(2.0/4.0)
hello-interval 1 1 sec/1
dead-interval 3 3 sec/1
hold-interval 3 3 sec/1
initial-ttl 2 2 hops
next hello sent in 00:00:00.3
Member ports: ethe 2/5 to 2/8
Operational ports: ethe 2/5 ethe 2/8
Forwarding ports: ethe 2/5 ethe 2/8
Restart ports: 2/5(1) 2/6(1) 2/7(1) 2/8(1)