Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 67)

Multi-Service IronWare Switching Configuration Guide 37
53-1003036-02
Displaying Network Processor statistics
1
Clearing the NP statistics counters
You can clear the NP statistics counters for an entire device or selectively by port or slot using the
clear np statistics command as shown in the following.
Brocade# clear np statistics
Syntax: clear np statistics [ethernet <slot/port> ] [slot <slot-num> ]
You can use the ethernet option and specify a <slot/port> variable to clear NP statistics for an
individual port.
You can use the slot option and specify a <slot-num> variable to clear NP statistics for an individual
interface module.
TABLE 11 Relationships between TX counters
Tx Raw Good Packets =
= Tx Receive From TM Packets - Tx Bad Packets
Tx Unicast Packets + Tx Broadcast Packets + Tx Multicast Packets + Tx Source Port
Suppression Drop
Tx Sent to MAC =
= Tx IPv4 Packets + Tx IPv6 Packets + Tx Others
Tx Raw Good Packets – Tx Source Port Suppression Drop – Tx ACL drop - Tx RL Drop
– Tx Multicast TTL drop