Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 643)

Multi-Service IronWare Switching Configuration Guide 613
53-1003036-02
About Multi-Chassis Trunk (MCT)
18
3. Create a cluster client interface.
Brocade(config-cluster-TOR-client-2)#client-interface ether 1/5
4. Deploy the cluster client.
Brocade(config-cluster-TOR-client-2)deploy
TOR-B
Creating LAG-1
See
Figure 176 and “Creating LAG-1” for additional information on creating a LAG.
1. Create a LAG with the LAG ID option.
Brocade(config)# lag 1 dynamic id 1
Brocade(config-lag-1)#
2. Define the port the LAG will be using:
Brocade(config-lag-1)# ports ethernet 1/6
3. The primary port must be explicitly assigned using the primary-port command.
Brocade(config-lag-1)# primary-port 1/1
4. Deploy a LAG as shown below.
Brocade(config-lag-1)# deploy
Assign a name to an individual port within a LAG.
Brocade(config-lag-1)# port-name lag-client-2:1/2 ethernet 1/6
Creating LAG 2
See
Figure 176 and “Creating LAG-1” for additional information on creating a LAG.
1. Create a LAG as shown below.
Brocade(config)# lag 2 dynamic id 2
Brocade(config-lag-2)#
2. Define the port the LAG will be using.
Brocade(config-lag-2)# ports ethernet 1/7
3. The primary port must be explicitly assigned using the primary-port command.
Brocade(config-lag-2)# primary-port 1/7
4. Deploy a LAG as shown below.
Brocade(config-lag-2)# deploy
5. Assign a name to an individual port within a LAG.
Brocade(config-lag-2)# port-name lag-client-3:1/2 ethernet 1/7