Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 489)

Multi-Service IronWare Switching Configuration Guide 459
53-1003036-02
RSTP support for PB and PBB
13
S-VLAN Configuration
Configure VPLS VLANs which will carry the PB traffic, the S-VLAN here is 300.
Brocade_ES-1(config)#router mpls
Brocade_ES-1(config-mpls)#vpls pb-vlan 1
Brocade_ES-1(config-mpls-vpls-pb-vlan)#pbb
Brocade_ES-1(config-mpls-vpls-pb-vlan-pbb)#vlan 300
Brocade_ES-1(config-mpls-vpls-pb-vlan-vlan-300)#tag ethernet 1/2
Brocade_ES-1(config-mpls-vpls-pb-vlan-pbb)#vlan 500
Brocade_ES-1(config-mpls-vpls-pb-vlan-vlan-300)#tag ethernet 1/3
C-VLAN Configuration
Configure C-VLAN 400 on customer port.
Brocade_ES-1(config-mpls-vpls-pb-vlan)#vlan 400
Brocade_ES-1(config-mpls-vpls-pb-vlan-vlan-400)#tag eth 1/1 eth 1/4
RSTP Configuration
Brocade_ES-1(config-mpls-vpls-pb-vlan)#rstp
Configuring CE-1
C-VLAN Configuration
Configure a regular Layer 2 VLAN with 400 (C-VLAN) and add port 1/1 to it.
Brocade_CE-1(config)#vlan 400
Brocade_CE-1(config-vlan-400)#tagged ethernet 1/1
Configuring CE-2
C-VLAN Configuration
Configure a regular Layer 2 VLAN with 400 (C-VLAN) and add port 1/4 to it.
Brocade_CE-2(config)#vlan 400
Brocade_CE-2(config-vlan-400)#tagged ethernet 1/4
Configuring RSTP on CE-1 and CE-2
RSTP Configuration
Brocade_CE-1(config)#vlan 400
Brocade_CE-1(config-vlan-400)#rstp
Use case 5: Edge RSTP- Interoperability with Brocade NetIron CES and Brocade
NetIron CER
In this scenario AS-1 is connected to AS-2 and ES-1 via S-tagged endpoint of different S-VLAN, and
ES-1 is a Brocade NetIron CES and Brocade NetIron CER device.
The following scenario is a case where RSTP is deployed on two different S-VLANs of the same
VPLS instance in a PB network. AS-1 is configured as a ROOT Bridge and RSTP is running on the
VPLS Instance on AS-1, AS-2, and ES-1. VPLS VLAN 200 is configured on AS-1 and AS-2 acts as a
S-VLAN which connects AS-1 and AS-2. VPLS VLAN 300 is configured on AS-1 and AS-2 acts as
another S-VLAN which connects AS-1 and AS-2 to the ES-1. AS-1 and AS-2 has VPLS VLAN 200 and
300 configured under same VPLS instance. VPLS VLAN 300 (S-VLAN) is configured with ES-1 and
connects to AS-1 and AS-2.