Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 166)

136 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Deploying a LAG
5
Tio Indicates the timeout value of the port. The timeout value can be one of the
following:
•
L – Long. The LAG group has already been formed and the port is therefore
using a longer message timeout for the LACPDU messages exchanged with the
remote port. Typically, these messages are used as confirmation of the health
of the aggregate link.
•
S – Short. The port has just started the LACPDU message exchange process
with the port at the other end of the link. The S timeout value also can mean
that the link aggregation information received from the remote port has expired
and the ports are starting a new information exchange.
Agg Indicates the link aggregation state of the port. The state can be one of the
following:
•
Agg – Link aggregation is enabled on the port.
•
No – Link aggregation is disabled on the port.
Syn Indicates the synchronization state of the port. The state can be one of the following:
•
No – The port is out of sync with the remote port. The port does not understand
the status of the LACPDU process and is not prepared to enter a LAG link.
•
Syn – The port is in sync with the remote port. The port understands the status
of the LACPDU message exchange process, and therefore knows the LAG group
to which it belongs, the link aggregation state of the remote port, and so on.
Col Indicates the collection state of the port, which determines whether the port is ready
to send traffic over the LAG link:
•
Col – The port is ready to send traffic over the LAG link.
•
No – The port is not ready to send traffic over the LAG link.
Dis Indicates the distribution state of the port, which determines whether the port is
ready to receive traffic over the LAG link.
•
Dis – The port is ready to receive traffic over the LAG link.
•
No – The port is not ready to receive traffic over the LAG link.
Def Indicates whether the port is using default link aggregation values. The port uses
default values if it has not received link aggregation information through LACP from
the port at the remote end of the link. This field can have one of the following values:
•
Def – The port has not received link aggregation values from the port at the
other end of the link and is therefore using its default link aggregation LACP
settings.
•
No – The port has received link aggregation information from the port at the
other end of the link and is using the settings negotiated with that port.
TABLE 25 Show LAG information (Continued)
This field... Displays...