Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 98)

68 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Verifying available flash space on the management module before an image is copied
3
For example, to display a directory of the files in flash memory, if flash memory has the
management focus, enter the following command.
Syntax: dir | ls [path-name]
You can enter either dir or ls for the command name.
Specify the path-name parameter to display the following:
• The files that match the value for a flash memory directory, or flash card directory/subdirectory
you specify
• The files that match the value for a name you specify
For example, to list only files that contain a *.tmp suffix in flash memory, if flash memory is the
current management focus, enter a command such as the following.
Brocade# dir
Directory of /flash/
07/28/2003 15:57:45 3,077,697 1060.tmp
07/28/2003 15:56:10 3,077,697 14082.tmp
07/28/2003 16:00:08 3,077,697 2084.tmp
07/25/2003 18:00:23 292,701 boot
00/00/0 00:00:00 12 boot.ini
07/28/2003 14:40:19 840,007 lp-primary-0
07/28/2003 15:18:18 840,007 lp-secondary-0
07/28/2003 09:56:16 391,524 monitor
07/28/2003 15:08:12 3,077,697 primary
07/28/2003 16:02:23 1,757 startup-config
07/25/2003 18:02:14 1,178 startup.sj2
07/28/2003 14:28:47 1,662 startup.spa
07/26/2003 12:16:29 1,141 startup.vso
07/25/2003 18:11:01 1,008 startup.vsr
07/28/2003 09:40:54 1,554 startup.vsrp.ospf
15 File(s) 14,683,339 bytes
0 Dir(s) 15,990,784 bytes free
Brocade# dir *.tmp
Directory of /flash/
07/28/2003 15:57:45 3,077,697 1060.tmp
07/28/2003 15:56:10 3,077,697 14082.tmp
07/28/2003 16:00:08 3,077,697 2084.tmp
3 File(s) 9,292,701 bytes
0 Dir(s) 15,990,784 bytes free