Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 947)

Multi-Service IronWare Switching Configuration Guide 917
53-1003036-02
Displaying BFD information
25
NOTE
On a non POS module, BFD makes use of PBIF transmit assist to send out the packets with the
maximum transmit interval of 6.4 seconds.
Displaying BFD neighbor information
The following example illustrates the output from the show bfd neighbor command.
Brocade# show bfd neighbor
Total number of Neighbor entries: 2
NeighborAddress State Interface Holddown Interval R/H
10.14.1.1 UP eth 3/1 300000 100000 Y/S
10.2.1.1 UP eth 2/1 300000 100000 Y/S
Syntax: show bfd neighbor [interface ethernet slot/port | interface ve port-no]
The interface ethernet option displays BFD neighbor information for the specified ethernet
interface only.
The interface ve option displays BFD neighbor information for the specified virtual interface only.
This display shows the following information.
LP The number of the interface module that the Current Session Count is
displayed for.
Sessions The number of Transmit (Tx) and Receive (Rx) BFD sessions currently
operating on the specified interface module.
BFD Enabled ports count The number of ports on the device that have been enabled for BFD.
Port The port that BFD is enabled on.
MinTx The interval in milliseconds between which the device desires to send a
BFD message from this port to its peer.
MinRx The interval in milliseconds that this device desires to receive a BFD
message from its peer on this port.
Mult The number of times that the device will wait for the MinRx time on this
port before it determines that its peer device is non-operational.
Sessions The number of BFD sessions originating on this port.
TABLE 125 Display of BFD information
This field... Displays...
Total number of Neighbor entries The number of neighbors that have established BFD sessions with ports on
this device.
NeighborAddress The IPv4 or IPv6 address of the remote peer.
State The current state of the BFD session:
Up
Down
A.DOWN – The administrative down state.
INIT – The Init state.
UNKNOWN – The current state is unknown.
TABLE 124 Display of BFD information (Continued)
This field... Displays...