Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 574)

544 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
ERP support for PBB (Brocade MLX series and Brocade NetIron XMR)
15
• Configure PBB VPLS VLANs for carrying PB/PBB traffic
• Configure the topology group
- ERP protocol over the master VLAN
- PB/PBB traffic over the member VPLS VLANs
Blocking of L2 protocols for PBB
The configurations discussed will be blocked
• ERP is the only protocol that will be supported for PBB in NetIron R05.3.00, any other protocol
configuration with PBB is blocked.
• If a topology group is configured with PBB VPLS member VLANs, then only ERP can be enabled
on the master VLAN.
• If the master VLAN of a topology group is enabled with a protocol other than ERP, then PBB
VPLS member VLAN configuration will not be allowed on that topology group.
Sample configurations
PB Ring node
FIGURE 151 PB ring node
PE-2 ERP Configuration with regular VLAN 201
vlan 201
tagged ethe 1/1 ethe 1/2
!
erp 201
left-interface vlan 201 ethe 1/1
right-interface vlan 201 ethe 1/2
sub-ring
raps-default-mac
rpl vlan 201 ethe 1/2
enable
!
PE-2 Topology group configuration
!
topology-group 1
master-vlan 201
member-vlan vpls id 1 vlan 200
!