Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 580
550
Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Viewing ERP operational status and clearing ERP statistics
15
I/F
Port
ERP port state
Interface status
Interface type
L 1/12
blocking
normal
rpl
R 1/11
forwarding
normal
non-rpl
RAPS sent
RAPS rcvd
RAPS dropped RAPS ignored
Oper state changes
3 3 0 0
0
summarizes the table fields and their meanings.
TABLE 67
Summary of CLI output for show erp command
This field...
Displays...
ERP id
The ERP ID is the number that was configured at setup. The ERN appends this
number to the permanent portion of the MAC address (01-19-A7-00-00) used
for ERP.
Status
Enabled or disabled
Operational state
Init, Idle, Protection, Manual Switch, Forced Switch or Pending
Node role
rpl-owner, non-rpl-node or rpl-node
Topology group
<topology group id> or “- “ ( - means N/A)
Ring type
Major-ring or Sub-ring
Timers
Configuration value for each timer
Interfaces (I/F)
L (left) or R (right)
Port
<slot/port>
ERP port state:
disabled, blocking, forwarding
Interface status:
normal, signal-fail, manual-switch or forced-switch
Interface type:
rpl or non-rpl
RAPS sent:
RAPS sent by MP (self generated)
RAPS rcvd:
RAPS received by MP
RAPS dropped:
RAPS dropped by MP
RAPS ignored:
RAPS ignored (for example, the guard-timer, or non regular type)