Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 548
518
Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Initializing a new ERN
15
shows the next sequence of events. The actions of each ERN are:
•
ERN 1, from the Pending state, unblocks the left interface, stops sending R-APS (NR) and stays
in the Pending state. Now both interfaces are in the forwarding state.
•
ERN 2 takes no action.
•
ERN 3 takes no action.
•
ERN 4 stays in the Pending state and transmits R-APS (NR) messages. The left interface is
blocked, and the right interface is in the forwarding state.
FIGURE 131
Initializing an ERP topology - IV
shows the next sequence of events. Next ERN 2 initializes. The actions of each ERN are:
•
ERN 1 stays in the Pending state.
•
ERN 2 (RPL owner), from the Init state, stops the guard timer, stops the WTB timer, blocks the
RPL, unblocks the non-RPL port, enters the Pending state, transmits R-APS (NR) messages,
and starts the WTR timer.
•
ERN 3 takes no action.
•
ERN 4 stays in the Pending state and transmits R-APS (NR) messages. The left interface is
blocked.
FIGURE 132
Initializing an ERP topology - V