Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 587
Advertising
Multi-Service IronWare Switching Configuration Guide
557
53-1003036-02
Layer 2 redundancy
16
You can reduce the sensitivity of a VSRP device to failover by increasing its configured VSRP
priority. For example, you can increase the configured priority of the VSRP device on the left in
to 150. In this case, failure of a single link does not cause failover. The link failure
caused the priority to be reduced to 100, which is still equal to the priority of the other device. This
is shown in
.
FIGURE 161
VSRP priority bias
Advertising