Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 267)

Multi-Service IronWare Switching Configuration Guide 237
53-1003036-02
About IEEE 802.1ad
9
TABLE 40 show interfaces command output
This field... Displays...
Module type Port# is State The module type variable specifies a type of interface module, such as
10GigabitEthernet.
The port# variable specifies the port number for the interface module.
The state variable if the interface module is up or down.
Line protocol is status The status variable specifies if the line protocol is up or down.
If the interface is down due to Link Fault Signaling - Remote Fault
Notification (LFS or RFN) the reason is indicated as: “(remote fault)”.
STP Root Guard is status The status variable specifies if the STP Root Guard is enabled or
disabled.
STP BPDU Guard is status The status variable specifies if the STP BPDU Guard is enabled or
disabled.
Hardware is module type The module type variable specifies a type of interface module, such as
#Gigabit Ethernet.
Address is MAC- address The MAC- address variable specifies the MAC address of the port.
Configured speed and actual speed The speed that the module has been configured to operate at, and the
actual speed it is currently operating at.
Configured port speed and actual duplex The port capacity that the module has been configured to operate at,
and the actual speed it is currently operating at.
Member of VLAN # (untagged)
port# L2 VLANS (tagged)
Port is in dual mode/untagged/tagged
mode
Port state is status The VLAN# (untagged) variable specifies a port that is a member of
only 1 VLAN.
The port# L2 VLANS (tagged) variable specifies a port that is a
member of multiple ports and untagged.
A port is in dual- mode specifies member VLAN ports as untagged and
tagged. The default mode is dual-mode.
The status variable identifies the flow of traffic as forwarding or
disabled.
STP configured to status
Priority level
Flow control status The status variable specifies if the STP is ON or OFF.
The priority level assigned to the port-based VLAN. The priority level is
on scale from 0-7. The default is 0.
The status variable is enabled or disabled.
Priority force status The status variable specifies if the priority force on a port is disabled
on enabled.
Drop precedence level value Identifies the TOS or DSCP value in the IPv4 or IPv6 packet header.
The value variable specifies the drop precedence on a scale from 0-3.
Packets that contain a DSCP value of 0 are least likely to be dropped
and packets with a value of 3 are most likely to be dropped. The
default value is 0.
Drop precedence force status The status variable specifies the drop precedence force as enabled or
disabled. Identifies the drop precedence if the force command is
configured for a specific ingress port.
arp-inspection-trust configured to status The status variable specifies if arp-inspection-trust feature is
configured ON or OFF. The default trust setting for a port is untrusted.
Mirror status The status variable specifies if the port mirror command is configured
as enabled or disabled.
Monitor status The status variable specifies if the port monitor command is
configured as enabled or disabled.