Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 184)

154 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Deploying a LAG
6
The brief option displays summary information for any or all configured LAGs.
The deployed option limits the display to LAGs that are currently deployed.
The dynamic option limits the display to dynamic LAGs.
The Ethernet option displays the output for the specified Ethernet port.
The keep-alive option limits the display to keep alive LAGs.
The deployed option limits the display to static LAGs.
Table 27 describes the information displayed by the show lag command.
TABLE 27 Show LAG information
This field... Displays...
Total number of LAGS The total number of LAGs that have been configured on the device.
Total number of Deployed LAGS The total number of LAGs on the device that are currently deployed.
Total number of LAGs Created The total number of LAGs that have been created on the LAG. The total number
of LAGs available are shown also. Since keepalive LAGs do not use an ID, they
are not listed and do not subtract for the number of LAGs available.
LACP System Priority /ID The system priority configured for the device.
The ID is the system priority which is the base MAC address of the device.
LACP Long timeout The number of seconds used for the LACP Long timeout mode. This is only
applicable for dynamic or keepalive LAGs.
LACP Short timeout The number of seconds used for the LACP Short timeout mode. This is only
applicable for dynamic or keepalive LAGs.
The following information is displayed per-LAG in the show lag brief command.
LAG The name of the LAG.
Type The configured type of the LAG: static, dynamic, or keepalive
Deploy Status of LAG deployment:
Y – yes, LAG is deployed.
N – no, LAG is not deployed.
LAG The LAG ID number.
Primary The primary port of the LAG.
Port List The list of ports that are configured in the LAG.
The following information is displayed per-LAG the “show lag” command for each LAG configured.
LAG Configuration
Ports: List of ports configured in the LAG.
Primary Port: The primary port for the LAG.
LAG Type: The load sharing method configured for the LAG: hash-based.
LACP Key The link aggregation key for the LAG.
Deployment
LAG ID The LAG ID number.
Active Primary The LAG port where most protocol packets are transmitted. This is not the
same as the configured Primary Port of the LAG.
Port The chassis slot and port number of the interface.