Displaying symmetric load balancing information – Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 844
814
Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Configuring IP load sharing
19
Specifying a slot number and a network processor ID using the slot-number and np-id variables
limits the command to the ports supported by the specified network processor on the specified
interface module.
The no option is used to turn off the previously enabled symmetric load balancing option.
Displaying symmetric load balancing information
To display the symmetric load balancing information for the interface, enter the following
command.
Brocade# show load-balance symmetric-options
Symmetric Ethernet options -
Symmetric Ethernet is enabled on -
Slot 2
Slot 3
Symmetric IP options -
Symmetric IP is enabled on -
All Slots
Symmetric IPv6 options -
Symmetric IPV6 is enabled on -
Slot 1
Slot 2
Symmetric IP Layer 4 IP options -
Symmetric Layer 4 IP is enabled on -
Slot 2
Symmetric IPv6 Layer 4 IPV6 options -
Symmetric Layer 4 IPV6 is enabled on -
Slot 2
Symmetric INNER Ethernet options -
Symmetric INNER Ethernet is enabled on -
Slot 2
Symmetric INNER IP options -
Symmetric INNER IP is enabled on -
Slot 2
Symmetric INNER IPV6 options -
Symmetric INNER IPV6 is enabled on -