Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 597)

Multi-Service IronWare Switching Configuration Guide 567
53-1003036-02
Displaying VSRP 2
16
dead-interval The configured value for the dead interval. The dead interval is the number of
seconds a Backup waits for a Hello message from the Master for the VRID
before determining that the Master is no longer active.
If the Master does not send a Hello message before the dead interval expires,
the Backups negotiate (compare priorities) to select a new Master for the VRID.
NOTE: If the value is 0, then you have not configured this parameter.
hold-interval The number of seconds a Backup that intends to become the Master will wait
before actually beginning to forward Layer 2 traffic for the VRID.
If the Backup receives a Hello message with a higher priority than its own
before the hold-down interval expires, the Backup remains in the Backup state
and does not become the new Master.
initial-ttl The number of hops a Hello message can traverse after leaving the device
before the Hello message is dropped.
NOTE: A Foundry MRP ring counts as one hop, regardless of the number of
nodes in the ring.
next hello sent in time or
next backup hello sent in
time The amount of time until the Master/Backup sends its next hello message.
master router or backup
router The IP address or MAC address of the master or backup router, and the amount
of time remaining until the dead interval expires.
Member ports The ports in the VRID.
Operational ports The member ports that are currently up.
Forwarding ports The member ports that are currently in the Forwarding state. Ports that are
forwarding on the Master are listed. Ports on the Standby, which are in the
Blocking state, are not listed.
Link-Redundancy-port The status os the port on which link redundancy has been configured.
TABLE 69 CLI display of VSRP VRID or VLAN information (Continued)
This field... Displays...