Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 57)

Multi-Service IronWare Switching Configuration Guide 27
53-1003036-02
Link fault signaling
1
TX LFS is enabled on all ports. RX LFS is enabled on all ports except 3/1
Example Port configuration overwritten by global configuration
Brocade(config)#show run
Current configuration:
!
ver V5.3.0pT183
!
no spanning-tree
!
vlan 1 name DEFAULT-VLAN
!
hostname Brocade
!
end
Brocade(config)#show link-fault-signaling
Global Link Fault : RX ON TX OFF
PORT #: LINK FAULT:
PORT 2/1: RX ON TX OFF
PORT 2/2: RX ON TX OFF
TX LFS is disabled on all ports and RX LFS is enabled on all ports.
Brocade(config)#link-fault-signaling
Brocade(config)#show run
Current configuration:
!
ver V5.3.0pT183
!
no spanning-tree
!
vlan 1 name DEFAULT-VLAN
!
hostname Brocade
link-fault-signaling
!
end
Brocade(config)#show link-fault-signaling
Global Link Fault : RX ON TX ON
PORT #: LINK FAULT:
Brocade(config)# interface e 3/1
Brocade(config-if-e100000-3/1)#link-fault-signaling ignore-rx
Brocade(config-if-e100000-3/1)#show run
Current configuration:
!
ver V5.4.0iT163
module 1 ni-mlx-8-port-10g-m
module 3 ni-mlx-8-port-10g-m
!
link-fault-signaling
!
interface ethernet 3/1
link-fault-signaling ignore-rx
!