Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 247)

Multi-Service IronWare Switching Configuration Guide 217
53-1003036-02
transparent-hw-flooding lag-load-balancing
7
transparent-hw-flooding lag-load-balancing
Configures transparent VLAN flooding LAG load balancing on a specific VLAN when there is PBR to
TVF VLAN flooding.
Syntax transparent-hw-flooding lag-load-balancing
Command
Default
None
Parameters None
Command
Modes
VLAN configuration mode
Usage
Guidelines
The transparent-hw-flooding lag-load-balancing command configures transparent VLAN flooding
LAG load balancing on a specific VLAN when there is PBR to TVF VLAN flooding. Use no
transparent-hw-flooding lag-load-balancing command to disable the transparent VLAN flooding LAG
load balancing on a specific VLAN.
Examples The following example shows how to enable transparent VLAN flooding LAG load balancing on VLAN
100:
Brocade(config)#vlan 100
Brocade(config-vlan-100)#transparent-hw-flooding lag-load-balancing
To disable transparent VLAN flooding LAG load balancing on VLAN 100 use the following command:
Brocade(config)#vlan 100
Brocade(config-vlan-100)#no transparent-hw-flooding lag-load-balancing
Related
Commands
transparent-hw-flooding
show vlan vlan-id detail
Release Command History
Multi-Service IronWare
R05.6 This command was introduced.