BMW K 1100 LT/RS - Manual (Page 130)

13.12
Removing and installing throttle rail
• Remove fuel tank.
• Remove left fairing side section.
• Remove left-hand heat-insulating bulkhead.
• Release fuel hose (1) at injection rail.
• Release injection rail (2) at cylinder head and pull
out together with injectors.
• Disconnect multiplug at throttle sensor.
L
Note:
Only remove throttle sensor if it is to be replaced
(basic setting necessary).
• Detach throttle cable (3).
• Detach operating cable (4) for start speed in-
crease. • Release hose clips at the air intake lines, loosen
at the throttle coupling.
• Remove throttle rail from stub pipe.
• Pull air return pipe (5) off throttle rail.
• Disconnect indicator lamp plug connection for
start speed increase.
• Install in the reverse order of removal.
L
Note:
Do not change the location of the hose clips on the
throttle coupling unions.
Firmly tighten hose clips at the air intake lines with
special tool, BMW No. 31 1 500.
LT130100
1
3
4
2
LT130110
5