BMW K 1100 LT/RS - Manual (Page 187)

23.13
Removing selector shaft
• Release setscrew (arrow) (secured with Loctite).
• Pull out selector shaft together with gearshift le-
ver.
Removing segment
• Remove retaining ring (arrow).
• Remove segment (1) together with coil spring (2)
and limit stop (3).
• Install in the reverse order of removal.
e
Caution:
Secure setscrew with Loctite 242; screw and hole
must be clean and free of grease.
X
Tightening torque:
Setscrew, selector shaft ............................... 17 Nm
• Drive in transmission case bent by 10 mm and fit
cap.
Removing and installing shaft sealing
ring on input shaft
• Drive out shaft sealing ring from inside.
• Fit shaft sealing ring using drift,
BMW No. 23 1 760 and handle,
BMW No. 00 5 500 .
LT230110
LT230120
1
2
3
23 1 760
LT230130
00 5 500