BMW K 1100 LT/RS - Manual (Page 58)

11.24
Installing valve and valve stem seal
L
Note:
If a valve was removed, the valve stem seal must be
renewed.
• Oil the stem when installing the valve.
• Insert the lower spring plate.
• Push assembly sleeve (arrow),
BMW No. 11 1 960, on to the valve stem.
• Drive in sealing ring (1) with drift,
BMW No. 11 5 601, until the drift reaches the
cylinder head.
e
Caution:
Remember to remove the assembly sleeve from the
valve stem.
• Insert the valve spring.
• Install the upper spring plate.
• Clamp the valve spring, lightly oil the valve collets
and insert them, then release the spring.
• Clean and oil the bucket-type tappet before in-
serting.
1
LT110320