BMW K 1100 LT/RS - Manual (Page 49)

11.15
Stripping down and re-assembling
intermediate flange
Removing the driver bearing
• Bearing plate (1)
• Cup spring (2)
• Pull out ball bearing (3) with counter-support,
BMW No. 00 8 572, and internal puller 21/2,
BMW No. 00 8 571.
• Seeger circlip (4)
Installing driver bearing
• Heat the intermediate flange at the bearing seat
to 120 °C.
• Press the ball bearing in as far as the Seeger cir-
clip.
4
3 2
1
j 120
LT110120
• Insert the cup spring with the larger diameter fac-
ing the bearing.
• Install the bearing plate with the large cutout fac-
ing upwards.
• The retaining screws must be clean and free
from grease; insert them with Loctite 243.
X
Tightening torque:
Bearing plate.................................................. 9 Nm
LT110130