BMW K 1100 LT/RS - Manual (Page 194)

23.20
Installing transmission shafts
• Heat bearing points for intermediate shaft and
output shaft in the housing to 80°C.
• Fit input shaft.
• Install intermediate shaft and output shaft to-
gether.
• With the aid of light blows (plastic-headed ham-
mer), check that bearing is fitted in the base of
the seat.
Installing gearshift forks
• Fit gearshift fork for 5th gear (1) with short guide
end facing upward in the bottom section of the
output shaft.
• Fit gearshift forks for 1st and 2nd gear (2) with
short guide end facing downward in the upper
section of the output shaft.
• Fit gearshift fork for 3rd and 4th gear (3) with
short guide end facing downward in the interme-
diate shaft.
L
Note:
Lightly coat sleeves of guide pins with grease when
fitting.
LT230290
80°C
LT230300
2
3
1