BMW K 1100 LT/RS - Manual (Page 257)

33.21
Installing swinging arm
• Slide swinging arm over drive shaft.
• Lift drive shaft over the support surface in the
swinging fork and press forward swinging arm as
far as possible until gaiter snaps in position at the
gearbox neck.
• Coat bearing pin of fixed bearing with
Optimoly TA and install and firmly tighten with
special tool BMW No. 26 1 660 .
• Install bracket (1) for line of electric side stand
switch.
X
Tightening torque:
Swinging arm fixed bearing ............................ 9 Nm
• Coat bearing pin of loose bearing with
Optimoly TA, install, firmly tighten and secure
locknut.
X
Tightening torques:
Bearing pin of loose bearing
(clean thread + Loctite 270)............................ 7 Nm
Locknut ........................................................ 41 Nm
Installing footrest plates
• Install left footrest plate.
• [ABS] Note earth (ground) cable.
• Mount silencer.
X
Tightening torques:
Footrest plate to gearbox ............................ 15 Nm
Silencer to footrest plate ................................ 9 Nm
• Install right footrest plate.
• Carefully arrange all leads and hoses; ensure
they are not pinched.
• [ABS] Note earth (ground) cable.
X
Tightening torques:
Footrest plate to gearbox ............................. 15 Nm
[ABS I] Support bracket,
pressure modulator ...................................... 17 Nm
26 1 660
LT330310
LT330390
1