BMW K 1100 LT/RS - Manual (Page 277)

34.19
[ABS II] Installing ABS unit
• Install ABS unit (6).
• Reconnect central plug (5).
e
Caution:
Do not tilt the cables or the insulation may be dam-
aged.
• Push 2-pin plug (4) on correvtly and as far as it
will do, then press the two wires into the centre
(smal ler) cable entries.
• Attach both plugs of the connecting cable/wiring
harness to the threaded pins with the crimp fac-
ing forwards.
• Press the cables into the remaining cable guides.
• Tighten the nuts.
e
Caution:
Use new self-locking nuts.
X
Tightening torques:
Battery –/M5................................................ 3.5 Nm
Battery +/M5 ................................................. 3 Nm
• Fit a new cover.
e
Caution:
When sliding on, make sure that all cables are posi-
tioned correctly in their guides.
Always use a new cover.
The old cover must be scrapped.
• Screw ABS brake lines (1) firmly to the ABS unit.
• Fill/bleed the brake system.
• Install the coolant level equalising tank.
• Install the battery.
• Install the Motronic control unit.
• Install the battery covers.
• Install the fuel tank.
X
Tightening torques:
ABS unit to mounting
M6 screw ....................................................... 9 Nm
Brake line to ABS unit .................................. 18 Nm
Bleed screw at ABS unit................................. 9 Nm