BMW K 1100 LT/RS - Manual (Page 83)

11.49
Installing cylinder head cover
• Insert reamed bolt (arrow), BMW No. 11 1 980,
into inner front hole.
• Press centering pin, BMW No. 00 5 500, into
mount under the third camshaft bearing.
• Install the cylinder head cover gasket with the
half-moon cutouts first. The marks at the front
and rear of the gasket and the cylinder head cov-
er must coincide.
• Oil the gasket and half-moons lightly.
• Press in the half-moon on the gearbox side first.
• Apply a small amount of 3-Bond 1209 to the joint
area of the cylinder head and timing case cover.
• Attach the cylinder head cover with gasket.
• Insert all retaining screws as far as possible.
• Tighten the retaining screws in a crosswise pat-
tern, working from the inside outwards.
X
Tightening torque:
Cylinder head cover ....................................... 8 Nm
• Take out the reamed and centering screw and in-
sert the remaining retaining screws.
LT110720
11 1 990
LT110730